Operator`s manual

3
R
Section 2
ASSEMBLY INSTRUCTIONS2.1
- NOTE -
Use the illustrated parts list as a part number
refer en ce w h en followi ng th e a s se mbly
instructions.
Remove all packaging materials. Lay out the 1.
mounting hardware and the catcher assembly parts
for easy access. Prepare the work area making sure
that it is a clean, safe environment.
WARNING
Do not operate without discharge chute, mulch
kit, operator controlled discharge chute (OCDC),
or entire grass catcher installed.
Remove the discharge chute from the cutter deck. 2.
See Figure 2-1.
- NOTE -
Do not discard the discharge chute or mounting
hardware. The discharge chute MUST be
reinstalled any time the grass catcher has been
removed from the machine.
Remove the right side belt cover to gain access to 3.
the spindle assembly. Remove the front u-nut from
the cutter deck bracket. See Figure 2-1.
- NOTE -
Retain the original belt cover. This cover MUST be
reinstalled any time the complete catcher system
is removed.
RIGHT SIDE OF 61"
CUTTER DECK SHOWN
(Note: Some parts not shown for viewing purposes.)
REMOVE DISCHARGE
CHUTE AND
HARDWARE
INSTALL PULLEY
ON RH SPINDLE SHAFT -
ON TOP OF EXISTING
SPINDLE DRIVE
PULLEY
REMOVE EXISTING
RT. SIDE BELT
COVER
REMOVE (2)
U-NUTS
Discharge Chute RemovalFigure 2-1.
Install the grass catcher pulley onto the spindle 4.
assembly. Apply loctite to both pulley setscrews and
tighten. See Figure 2-1.
Remove the "Turbo" baffle from the cutter deck. 5.
Using the original hardware, install the new "Turbo"
baffle. Install the baffle weldment. See Figure 2-2.
UNDER SIDE OF
VELOCITY-PLUS
CUTTER DECK SHOWN
Custom Cut Baffle
Turbo Baffle
48V - 424683
52V - 424211
Baffle Weldment
48V & 52V - 452383
Grass Catcher BafflesFigure 2-2.
- NOTE -
Do not discard the original "Turbo" baffle. This
baffle may be reinstalled any time the grass catcher
has been removed from the machine.
Install the blower mounting bracket to the 6.
deck using carriage bolts (p/n 04003-11),
lockwashers, and nuts. Do not fully tighten
the hardware at this time. See Figure 2-3.
ELASTIC STOP
NUT
FLAT WA SHER
CARRIAGE BOLT
Blower Mounting Post InstallationFigure 2-3.