Operating Manual

Fuse and Bulb
112
Replace front snow chain bulb
Replace the front snow chain bulb
− Remove the front snow chain
Open the storage box and then you may see 2 screws. Use a
cross screwdriver to loosen the screws counterclockwise. After
the screws are loosened, pull down the celling light lightly to
remove the front celling light. Then disconnect the celling light
connector.
− Replace the front snow chain bulb
Rotate the bulb holder counterclockwise to remove the bulb.
Replace it with a spare bulb.
− Install the front snow chain
After the bulb is replaced, reconnect the wire harness
connector, clamp the celling light into dome again and
re-tighten the mounting bolts.
Replacement of Rear Snow Chain Bulb
Rear snow chain removal port
Replacement of rear snow chain bulb