Operating Manual

Fuse and Bulb
108
− Remove the front bumper. Use the tool to remove 4 mounting
screws from headlight and then remove it.
− Remove the rubber rear cover ② of light fixture and you may
see the position light holder, then remove the high beam light
bulb.
− Replace it with one spare bulb of high beam light and
reinstall the position light. Close the rubber back cover.
− Reinstall the headlight onto vehicle, tighten 4 mounting screws
and then reinstall the front bumper.
Instruction
 The position light which is LED type cannot be replaced. If
there is any fault in the turn signal light, please go to
KANDI-authorized service station to replace the headlight.
 The rear cover of front fog light is locked and the bulb of fog
light cannot be replaced. If there is any fault in front fog light,
please go to KANDI-authorized service station to replace the
front fog light.