User`s guide

Thank you for choosing the SBS BF400
Bluetooth earpiece. Before using it for the first
time, follow the instructions printed below.
CCHHAARRGGIINNGG TTHHEE BBAA
TTTTEERRYY OOFF TTHHEE EEAARRPPIIEECCEE
The earpiece uses a battery with high
performance “Lithium Polymer” technology.
The first time you use the earpiece, the battery
inside may not be charged and it will be
necessary to charge it up.
RReecchhaarrggee..
Connect the battery recharger to
the electric socket and to the earpiece. The
red light will come on and the recharging
process will begin. When the battery has been
recharged the light will go off. It will take
about two hours to fully recharge the battery.
BBaatttteerryy ddeeaadd..
When the BF400 battery has
almost run down, the light will flash red and a
beep will be heard in the earpiece.
NNOOTTEE::
to extend the life of the battery, we
recommend that you leave the BF400
switched off while recharging and only
recharge it when it is dead. If the BF400 has
not been used for some time, it may take a
few minutes for the red light to come on.
SSttaattuuss LLEEDD
Stand-by Flashing BLUE
“Find me” mode Flashing RED/BLUE
Calling Quick flashing BLUE
Battery dead Slow flashing RED
Recharge Fixed RED
SSWWIITTCCHHIINNGG OONN,, CCOONNNNEECCTTIINNGG AANNDD
SSWWIITTCCHHIINNGG OOFFFF TTHHEE EEAARRPPIIEECCEE
SSwwiittcchhiinngg oonn..
Press the multifunction button and keep it
pressed until the blue light flashes three times
(about 3 seconds). The BF400 will switch to
stand by.
CCoonnnneeccttiinngg..
After switching on the BF400,
briefly press the multifunction button to
connect the earpiece to the last device with
which it has been associated (only after
making the association).
SSwwiittcchhiinngg ooffff..
Press the multifunction button
and keep it pressed until the red light flashes
three times (about 3 seconds).
AASSSSOOCCIIAA
TTIIOONN OOFF TTHHEE EEAARRPPIIEECCEE WWIITTHH AA
BBLLUUEETTOOOOTTHH DDEEVVIICCEE
Before using the Bluetooth headset, you must
associate it with the device you are going to
use it with (telephone/PC).
AASSSSOOCCIIAATTIIOONN
• Ensure that the BF400 is switched off. Press
the multifunction button and keep it pressed
until the light starts flashing red/blue (about
6 seconds), in this way the earpiece is ready
to be picked up by other devices (
“find me”
mode).
• Run the search for new Bluetooth
accessories from your device (phone/PC)
**
.
At the end of the search the name of our
earpiece will appear on the display (the
name may vary from device to device).
• Select the BF400 and, when requested to do
so, enter the PIN 0000, then press
“OK” .
• The phone/PC will tell you that the new
bluetooth device has been associated, while
the BF400 light will flash blue (
stand-by ).
NNOOTTEE::
With some phones it might be
necessary to authorise connection
from the phone.
**
To make the association, follow the
instructions in the user manual supplied
with the phone or with the PC Bluetooth
BBFF440000GGBB
VVOOLLUUMMEE ((++))
VVOOLLUUMMEE ((--))
LLEEDD
EEAARRPPHHOONNEE
MMUULLTTIIFFUUNNCCTTIIOONN
BBUUTTTTOONN
MMIICCRROOPPHHOONNEE