Operating instructions

Configuring server flows
A server flow is required for the IP Office.
Before you begin
You must be logged into the SBCE Control Center as Admin.
Procedure
1. In the navigation tree on the left, expand System Management.
2. Select Device Specific Settings and then End Point Flow.
3. Select Server Flow.
4. Click Add.
5. Enter a name for the IP Office flow.
6. In the Server Configuration field, select the IP Office server configuration.
7. In the Received Interface field, select the external signaling interface.
8. In the Media Interface field, select the IP Office interface.
9. In the Signaling Interface field, select the IP Office interface.
10. In the End Point Policy field, select the policy group created for IP Office.
11. In the Routing Profile field, select the default routing profile.
12. If required, in the Topology Hiding Profile, select profile created for IP Office.
13. Click Finish.
Example IP Office server flow
Note:
If doing remote worker and trunking to the same SM you will have two SM server flows. One
with the remote worker received interface and the default routing profile and the other with
the trunk received interface and the to_trunk routing profile
Configuring server flows
Configuring the Avaya Session Border Controller for IP Office Remote Workers September 2013 21