Operating instructions

See Administering Avaya Session Border Controller for Enterprise for additional information
on domain polices.
Configuring endpoint policy groups application rules
Clone an existing application rule as a starting point or create a new one. Do not change the
default.
Before you begin
You must be logged into the SBCE Control Center as Admin.
Procedure
1. In the navigation tree on the left, expand System Management.
2. Select Domain Policies and then Application Rules.
3. Click Add and enter a name for the one to be used by the IP Office End Point Policy
Group.
4. Click Next.
5. Check In and Out for Voiceand put in the amount of concurrent sessions required
for the license. Put the same value for Max Concurrent Sessions and Max
Sessions Per Endpoint.
It is best practice to put more than the license as this is not counted one or one with
license session. For example, if they have license of 300 concurrent sessions put
500 for each box.
If you need video, you must do the same for video. If you clone the default, Audio
is already enabled you only need to adjust the values and then enable video.
6. Click Finish.
7. Repeat to create a rule used by the Subscriber Flow End Point Policy Group. For
the subscriber flow rule, put the Max Concurrent Sessions higher than the license.
However, for Max Sessions Per Endpoint, the recommended value is 10. You can
use a higher value if required.
Configuring endpoint policy groups application rules
Configuring the Avaya Session Border Controller for IP Office Remote Workers September 2013 19