Operating instructions

Procedure
1. In the navigation tree on the left, expand System Management.
2. Select Device Specific Settings and then Global Profiles.
3. Select Topology Hiding.
4. Click on the default profile and then click Clone.
5. Enter a name and click Finish.
6. The profile just created is highlighted. Click Edit.
• If IP Office is configured to accept a specific domain then in the From, To, and
Request-Line field, select Overwrite, enter the domain name and click
Finish.
• If IP Office is configured to accept a specific domain then in the From, To, and
Request-Line field, select Destination IPand click Finish.
• If no special criteria is required, leave everything as Auto and click Finish.
Configuring endpoint policy groups
Create a new endpoint policy group. Do not change the default group.
Before you begin
You must be logged into the SBCE Control Center as Admin.
Procedure
1. In the navigation tree on the left, expand System Management.
2. Select Domain Policies and then End Point Policy Groups.
3. Click Add and enter a name for the IP Office server flow.
4. Click Next.
5. Choose the appropriate Rules and click Finish.
6. Click Add and enter a name for the subscriber flow.
7. Click Next.
8. Choose the appropriate Rules and click Finish.
Next steps
The following three procedures for end point policy groups show changing the application rule
for max sessions, the media rule for QoS and RTP or SRTP, and the signaling rule for QoS.
Configuring Session Border Controller Enterprise for IP Office Remote Workers
18 Configuring the Avaya Session Border Controller for IP Office Remote Workers September 2013
Comments? [e-mail]