User guide

the bottom the stand. This will allow the stand to sit
flat on a desk surface.
5. Install the phone
If you have installed the stand and are using the phone
on a desk:
Simply turn the telephone over so it rests on the stand.
Connect the phone cord to a phone jack and plug the
power adapter into a power outlet.
6. Install the phone on a wall
1. Connect the cord to the wall jack (A).
2. Coil the phone cord into the space provided on the
back of the phone (B).
3. Align the telephone so the hooks on the wall plate
(C) align with the wall-mount slots on the back of
Interactive Intelligence 390/480e P
hone User Guide
3
Installation and Setup
2. Attach the stand
If you plan to mount the phone on the wall, you do
not need to attach the stand, skip this step. If you plan
to use the phone on a desk, attach the stand by insert-
ing the tabs on the stand (marked with ) into the
slots on the bottom of the telephone. For a higher
viewing angle, use the slots marked . For a lower
viewing angle, use the slots marked . Then rotate
the stand towards the phone until it snaps into place.
3. Connect the cords
If you attached the stand to install the phone on a
desk, route both the phone cord and power adapter
cord through the opening in the stand. Insert the
phone cord into the slot on the back of the telephone
marked until it clicks into place. Insert the power
cord into the power jack marked . Note: You should
connect the power adaptor to a surge protector or power bar.
4. Press the cords into grooves
Press the cords into two of the grooves provided on
Interactive Intelligence 390/480e P
hone User Guide
2
2
Note: You may wish to purchase a short phone cord from a local
supplier for a wall installation.