User Manual

38
Pairing is generally only required once. If you
are installing multiple systems on dierent
bikes concurrently, you should conduct
pairing successively to avoid undesired
pairingofdierentpower2max powermeters
and bike computers.
You can repeat the pairing operation between
your power2max powermeter and your
compatible bike computer at any time. To
do so you need to activate your power2max
powermeter by turning the cranks. Your
power2max powermeter signals its readiness
withasingleashofthegreenLED.
3. Close the battery compartment again and
tighten the screws to 0.15NM. Make sure the
battery cover is clean and correctly seated.
IMPORTANT: The maximum torque of
the battery cover screws is 0.15NM. This
corresponds to tightening with 2 ngers.
Further tightening is NOT required and
can damage the battery cover or the
powermeter.