User Manual

37
7.3 Start-up
IMPORTANT:
Ensure that no torque is applied
to the power2max powermeter during
start-up, e.g., by putting load on a pedal.
1. Insert the battery of Type CR2450. Please
ensure the correct polarity. The positive pôle
(the side with the writing on it) should face
inward, towards the crank.
IMPORTANT: the USB micro-plus is used
only for diagnostic and maintenance
operations at the factory.
2. Your power2max powermeter has an
external LED that indicates the status of
the powermeter. This LED allows you to
easily check the status of your power2max
powermeter and is also used during initial
start-up.
After inserting the battery, the green LED
ashes for approximately 20 seconds. This
signals its readiness for use. During this period,
the power2max powermeter starts trans-
mitting its ANT+ signal and can be paired with
a compatible bike computer. Enter pairing mode
on your compatible bike computer. It should
recognize your power2max powermeter and
pair automatically with it.
english