Phau Ntawv Qhia

Instruction manual
91860, 91861, 91862, 91863, 98443, 98444, 98445, 98446
Salde Floodlight
We recommend cleaning with a soft dry cloth. Do not use solvents or abrasive cleaners as these could damage the finish.
For your safety, always switch off the power supply before cleaning.
Care and Safety
Technical data
220-240 V~, 50 Hz
Supply
Voltage:
Bulb
Type:
91860 / 98443: 10W LED module (SMD), 4000K 91861 / 98444: 20W LED module (SMD), 4000K
91862 / 98445: 30W LED module (SMD), 4000K 91863 / 98446: 50W LED module (SMD), 4000K
The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole luminaire shall be replaced.
This is a Class 1 product and must be earthed.
Waste electrical products should not be disposed of with household waste. Please recycle where facilities
exist. Check with your Local Authority or local store for recycling advice.
This product is rated at IP65.
IP 65
Caution! Risk of electric shock!
These units must be installed in a vertical position, and fitted up to 1.8-2.5m above the ground.
Accessories available: 98447, 91864, 91865, 91866
PIR sensor: 98447(white) / 91864(black)
The PIR sensor can be adjusted by turning the ‘SENS’ and ‘TIME’ screw using the small
screwdriver, allowing the detection distance to be altered to suit the location. The
detection angle is set at 120º. The detection range up to max 10 metres (＜24ºC). The
duration that lamp stays on can also be altered from 10±3 seconds - 7±2 minutes.
When adjusting the sensitivity (detection distance) in daylight it will be necessary to cover
the sensor to simulate night time.
Photocell sensor: 91866(black)
Ambient Light: <10 LUX on, ＞40LUX off
MANUAL OVERRIDE FUNCTION:
• How to activate override mode: When the sensor is in automatic sensor mode and the light
is ON, turn OFF-ON-OFF-ON the wall switch within 3 seconds, and the sensor will be in
override mode - the light will illuminate continuously.
• How to return to automatic sensor mode: Switch off the wall switch, wait 10 seconds and
then switch it back on, then the sensor will be back in automatic sensor mode.
MV sensor: 91865(black)
The PIR sensor can be adjusted by turning the ‘SENS’ and ‘TIME’ screw using the small
screwdriver, allowing the detection distance to be altered to suit the location. The detection
angle is set at 120º. The detection range up to max 10 metres. The duration that lamp stays
on can also be altered from 10±3 seconds - 7±2 minutes. When adjusting the
sensitivity (detection distance) in daylight it will be necessary to cover the sensor to
simulate night time.
91865(black) 91866(black)
V3 12/08/2021
EU Manufacturer: 1 Gnarrenburg, 27442
UK Manufacturer: BH17 7BY
91864(black)98447(white)
Light
Sensor
Plug & play
Conformity with all relevant EC Directive requirements.
Conformity with all relevant UKCA Directive requirements.