User Manual

8. The mobile base is now ready for your Professional Cabinet Saw, but before placing the saw on the mobile
base, it is important to rotate the rear hold-down bracket back as far as possible and to rotate the front
hold-down bracket forward as far as possible (see Fig. 8). To safely place the saw into the mobile base, you
will need at least four people to lift the saw off
the oor and then lower it onto the mobile base.
Have one person lift each corner of the cast iron
table top. If your saw has an extension table,
have the two people on the right side of the saw
lift on the extension rails near the outer corner
of the cast iron extension wing, not at the end of
the extension table. If a fth person is available, it
may be easier to have four people lift the saw and
the fth person slide the base under the saw.
Make sure the mobile base is centered
underneath the table saw and that the foot pedal
is in the front. The saw should sit on the front and
rear support straps extending across the interior
of the mobile base, and the front of the cabinet
should be touching the inside of the front face of
the mobile base frame (see Fig. 8).
5 SawStop Mobile Base Conversion Kit
Never place finge
rs,
toes or other bo
dy parts
under the mobile base.
!
WARNING
Never place fingers,
toes or other body parts
under the mobile base.
!
WARNING
Never place fingers,
toes or othe
r body parts
under the mobile base.
!
WARNING
1. Never p
lace fingers, to
es or other
body parts
under the
mobile base.
2. Always use
the saw and th
e mobile
base o
n a level sur
face.
3. Do
not continue t
o step on the
foot
pedal onc
e the upp
er limit is re
ached.
4. Lower
the saw bef
ore use. Never
use
the saw w
hen it is r
aised off the flo
or.
!
WARNING
R
aise
Never
place fingers,
toes or
other body parts
under the mo
bile base.
!
WARNING
L
ow
9. Locate the two self-tapping screws and the two M4.3 x 12 washers. Rotate the rear hold-down bracket until
the top hole is over the at face of the cabinet. Place one of the M4.3 x 12 washers over the end of one of
the self-tapping screws and use a drill with a
1
⁄
4
inch hex drive bit to mount the rear hold-down bracket to the
cabinet, as shown in Fig. 9a. There is no need to pre-drill a hole for the self-tapping screws, but be careful not
to overtighten the screws or the threads in the cabinet may strip out. Now, rotate the front hold-down bracket
until it is vertical and repeat the same procedure to mount it to the cabinet, as shown in Fig. 9b.
Fig. 8
Fig. 9a Fig. 9b
straps that
support the
saw
the front of cabinet
should be touching
the inside of the
front face of the
mobile base frame
M4.3x12
washer
self-tapping
screw
rotate the rear hold-
down bracket until the
top hole is over the at
face of the cabinet and
then mount it to the
cabinet with a washer
and a self-tapping screw
rotate the front
hold-down bracket
until it is vertical
and then mount it to
the cabinet with a
washer and a self-
tapping screw
M4.3x12
washer
self-tapping
screw
Congratulations, the assembly is now complete. Please see the Industrial Mobile Base Owner’s Manual for
instructions on how to use and adjust the mobile base and for information on hydraulic jack maintenance.
Assembling Your Mobile Base
rotate hold-down
bracket back
rotate hold-down
bracket forward