User Manual

4. Take the rear support assembly and move it forward until the two mounting holes align with the next set of holes
in the mobile base frame, as shown in Fig. 4. Mount the rear support assembly to the mobile base frame with
two new M8 x 15.7 shoulder socket screws from the hardware bag. Fully tighten the two M8 x 15.7 shoulder
socket screws with a 5 mm hex key.
R
aise
1. Never place fingers, toes or other
body parts under the mobile base.
2. Always use the saw and the mobile
base on a level surface.
3. Do not continue to step on the foot
pedal once the upper limit is reached.
4. Lower the saw before use. Never use
the saw when it is raised off the floor
.
!
WARNING
Never place fingers,
toes or other body parts
under the mobile base.
!
WARNING
Never place finger
s,
toes or other body
parts
under the mobile bas
e.
!
WARNING
L
ower
3 SawStop Mobile Base Conversion Kit
move the rear support
assembly forward until the
two mounting holes align
with the next set of holes
in the mobile base frame
Fig. 5a
Fig. 4
Assembling Your Mobile Base
Never place fingers,
toes or other body parts
under the mobile base.
!
WARNING
R
aise
. Never place finge
rs, toes or othe
r
body parts under the mobile base.
2. Always use the s
aw and the mobile
base o
n a level surface.
3. Do not continue to st
ep on the foot
pedal once the upp
er limit is reached.
4. Lower th
e saw before use. Ne
ver use
the saw when it
is raised off the floor
.
!
WARNING
L
ower
Fig. 5b
5. Locate the two conversion linkage bars and the remaining four M8 x 15.7 shoulder socket screws. Use two of
the M8 x 15.7 shoulder screws to install one of the conversion linkage bars on the left side of the mobile base
(see Fig. 5a). The screws pass through the clearance holes in the conversion linkage bar and thread into the
corresponding holes in the rear support assembly and the front bell link. Use the remaining two M8 x 15.7
shoulder socket screws to install the other conversion linkage bar on the right side of the mobile base (see
Fig. 5b). Fully tighten all four screws using a 5 mm hex key.
M8x15.7 shoulder
socket screw
M8x15.7 shoulder
socket screw
M8x15.7 shoulder
socket screws
M8x15.7 shoulder
socket screws
install a conversion
linkage bar on the left
side of the mobile base
install a conversion
linkage bar on the right
side of the mobile base
front
bell link
new
mounting
hole
original
mounting
hole
new
mounting
hole
rear support
assembly