User Manual

Never place fingers,
toes or other body parts
under the mobile base.
!
WARNING
The SawStop Industrial Mobile Base is designed to t the SawStop Industrial Cabinet Saw; however this mobile
base conversion kit allows the Industrial Mobile Base to be used with the SawStop Professional Cabinet Saw. In
order to convert the mobile base for use with the SawStop Professional Cabinet Saw, rst locate all of the conversion
kit components shown on page 1. All of the hardware needed to convert the mobile base is located in the hardware
bag. If you are missing the hardware bag or any of the other components, call the SawStop Service Department at
503-582-9934 for replacements.
1. Remove the original linkage bar on the
left side of the mobile base by unscrewing
the two M8 shoulder screws with a 5 mm
hex key (see Fig. 1). The shoulder screws
may be difcult to remove because they
were installed with a thread adhesive.
The original linkage bar and the two M8
shoulder screws may be discarded.
SawStop Mobile Base Conversion Kit 2
Assembling Your Mobile Base
Fig. 2
remove the original linkage
bar on the left side of the
mobile base
Fig. 1
L
ower
R
aise
1.
N
ever
pl
ace fingers, toes or
other
b
ody par
ts under th
e mob
il
e base.
2.
A
lways use the
sawan
d the mobil
e
base on a
level surface.
3. Do not
conti
nue t
o step on
the foot
ped
al o
nce the upp
er limit i
s reached.
4.
Lo
wer the saw
bef
ore
use. Never use
the saw when
it i
s
raised
of
f the floor.
!
WARNING
Fig. 3
2. Repeat the previous step to remove
the original linkage bar on the right
side of the mobile base (see Fig. 2).
3. You must now move the rear support
strap forward to accommodate the
smaller cabinet of the Professional
Cabinet Saw. Begin by removing
the two M8 shoulder screws that
mount the rear support assembly to
the mobile base frame with a 5 mm
hex key, as shown in Fig. 3. The rear
support assembly will be used in the
following step, but you may discard
the two M8 shoulder screws.
Never place fingers,
toes or other body parts
under the mobile base.
!
WARNING
remove the original
linkage bar on the right
side of the mobile base
remove the two M8 shoulder
screws that mount the rear
support assembly to the
mobile base frame
rear support
assembly
rear face of mobile
base frame
rear support
strap