Technical data

19 20
Connection of SAWO Control to the PCB.
Innova
Steam Generator
Control
230V 1N~
3,0 kW
KA
TSO OHJEIST
A
T
Ä
RKEÄ
T
LISÄ
OHJEET
LÄGG
MÄRKE
TI
L
L
DE
V
IK
T
IG
A
TIL
LÄ
GGSANVISNI
NGARN
A
BEACHTEN SIE DIE
ZUS
ÄTZLICHEN WICHTIGEN
ANWEISUNGEN IN DER
BEDIENUNGSANLEITUNG
READ
THE MANUA
L
FOR
ADDITIONA
L
IMPOR
T
AN
T
INSTRUCTIONS
Fan
(optional)
Light Scent Pump
(optional)
Before installation make sure that the generator is disconnected from the mains by switching off
the circuit breaker
1.
2.
3.
4.
5.
6.
7.
Note that there are two black RJ jacks on the board. One is for the control cable and the
other one for the optional slave unit. The control cable and slave cable can be connected
to either of these jacks, the order is insignificant.
Unscrew PCB cover on the side of the generator to get access on the PCB.
Guide the RJ12 control cable through the cable lead-in hole on the side of the generator
and then behind the side panel as described in the drawing below to reach RJ jacks on the
corner of PCB
Fasten the PCB cover and the top cover of the generator
Turn the mains on and switch on the power switch in the back of the generator
The software version should be displayed in the control unit
Turn the control unit on “On” mode to check it works properly
P100W
230VAC
P100W
230VAC
Max.
Power
Max.
Power
Max.
Power
Innova Steam
Generator Control
Terminal Block
SCENT
FAN
PUMP
TEMP
SWITCH
(24VAC)DRAIN
(230VAC) LIGHT
(12VDC)ILL
Demand Button (optional)
Terminal Connection of
Make sure that polarity is right “ILL” output is +12VDC
and 20mA.
Before installation make sure that the mains is disconnected
from the generator by turning off the circuit breaker.
1. Open the top cover of the generator
Guide the cable through cable lead-in on the side of
the generator.
Connect the wires to their designated places in the
terminal block.
If the demand button has light connect the light wire
on the "ILL" labeled terminal
3.
4.
2.
Terminal Block
SCENT
FAN
PUMP
TEMP
SWITCH
(24VAC)DRAIN
(230VAC) LIGHT
(12VDC)ILL
SCENT
FAN
PUMP
TEMP
SWITCH
(24VAC)DRAIN
(230VAC) LIGHT
(12VDC)ILL
Terminal Block
SCENT
FAN
PUMP
TEMP
SWITCH
(24VAC)DRAIN
(230VAC) LIGHT
(12VDC)ILL
If you have optional
dimmer in steam genera-
tor, make sure that the
ligths are dimmable before
connecting. Steam genera-
tor uses phase control to
regulate power for lighting.