Technical data

17
18
4.
5.
Figure 4
6.
Screw or glue the sensor cover to the
wall. Cover the temperature holder by
twisting the cap. Figure 4.
Pull the temperature sensor through
the steam room wall. Do not apply
staples or other material that may
damage the cable.
Insert the temperature sensor into the
sensor holder. Loosen the metal plate
to insert the temperature sensor.
Fasten the metal plate to tighten the
temperature sensor into the holder.
Apply silicone sealant on the hole in
the wall to create a moisture seal (Fig.
3). Make sure that there is no trace of
silicone on the sensor as it may
interfere its reading.
7.
AB
160 mm
84 mm
Wall
C
OPTIONAL
Interface Holders
Contact your SAWO distributor
Rectangle
Oval
Figure 3
Fig. 5
Silicone Sealant
Cable
Wall
Installation Instructions
Installing Control Unit
If the control is attached to a
concrete wall, provide a
control holder or equivalent
to mount the control into it.
NOTE
Check the most suitable area to place your steam generator control. The control and the
steam generator should be accessible for the user and maintenance. Do not install the
control unit inside the steam room! The cable of the control is 7.5 meters.
Mount the control in the wall, according to the specifications given below. Follow illustra-
tion.
SAWO Steam Control sets the temperature of your steam room. Mount the steam control
unit on an accessible area outside the steam room. It is recommended not to place the
steam control near to showers or similar wet places.
Never attempt to modify or to fix the steam control. Ask your licensed technician or your
nearest service centre for repair.
Before installation mains supply of the generator must be switch off from the circui breaker.