Installation and Operation Manual
Table Of Contents
- 1 Devices – an Overview
- 2 Explosion Protection
- 3 Functional Overview
- 4 Ambient Conditions
- 5 Electrical Data
- 6 Mechanical Dimensions and Materials
- 7 Installation and Mounting
- 7.1
- 7.2
- 7.3
- 7.4
- 7.5
- 7.6
- 8 Battery Replacement
- 9 Declaration of Conformity
- 10 Proper Usage
- 11 Setting Up Operation in SAVVY® Synergy Portal
- 12 FCC and ISED related statements
- 13 Storage and Shutdown
© 2019 by SAVVY Telematic Systems AG www.savvy-telematics.com
Version 1.2 07.08.2019 Page 16 of 22
16
Manual SAVVY® CargoTrac-ExR-M1
8 Battery Replacement
CargoTrac-ExR-M1 must not be installed in potentially
explosive areas!
The internal battery must not be replaced in potentially
explosive areas!
Use only original parts!
You will rarely need to replace the CargoTrac-ExR-M1 battery. Depending on the
desired messaging and position intervals, the internal battery will ensure trouble-free
operation for up to 15 years. Should it nevertheless be necessary to change the
battery, please proceed as follows:
• Make sure the Asset and the mounted CargoTrac-ExR device are in a place
located outside of the potentially explosive area.
• Remove the device from the mounting fixture.
• Place the device in an ESD-protected area and make sure individuals, tools
and other devices are ESD-protected before you open the device.
• Use a TORX-T20 screwdriver to remove the 10 screws on the base plate.
• Unplug the battery connector and remove the battery from its compartment.
Be sure to unlock the plug!