Installation and Operation Manual
Table Of Contents
- 1 Devices – an Overview
- 2 Explosion Protection
- 3 Functional Overview
- 4 Ambient Conditions
- 5 Electrical Data
- 6 Mechanical Dimensions and Materials
- 7 Installation and Mounting
- 7.1
- 7.2
- 7.3
- 7.4
- 7.5
- 7.6
- 8 Battery Replacement
- 9 Declaration of Conformity
- 10 Proper Usage
- 11 Setting Up Operation in SAVVY® Synergy Portal
- 12 FCC and ISED related statements
- 13 Storage and Shutdown
© 2019 by SAVVY Telematic Systems AG www.savvy-telematics.com
Version 1.2 07.08.2019 Page 10 of 22
10
Manual SAVVY® CargoTrac-ExR-M1
7.3 Pressure Relief Membrane Inspection
CargoTrac-ExR-M1 has a membrane on the back to relieve pressure in the event of
temperature fluctuations. This ensures that protection degree IP 67 is maintained
during operation. It is however necessary to make sure there is no damage to the
membrane before the device is put into operation. It is also necessary to be careful
and avoid damaging the membrane while installing the device.
Devices with a damaged pressure relief
membrane must not be installed and put
into operation.
7.4 X-y-z Axes Alignment During Installation
Before you begin installing or mounting the device, make a note of the mounting
position using the designations of the x-y-z axes on the type plate. The mounting
position needs to be included later on in the data set on the SAVVY® Synergy Portal.
This ensures that vibrations, blows, and accelerations can be attributed to the
corresponding axis: