Owner`s manual

8
Figure 17
Figure 18
10. INSTALLATING THE
MOUNTING PLATE
1. Remove the 1 of 3 screws from the
mounting ring and loosen the other 2
screws. (Do not remove)
2. Place the key holes on the light kit over
the 2 screws previously loosened from the
mounting ring, turn mounting plate until it
locks in place at the narrow section of the
key holes. Secure by tightening the 2
screws previously loosened and the one
previously removed. (Fig. 18)
Mounting ring
Mounting plate
Screws
Blade
Screws
Fiber
washers
Blades support
plates
Slot
Figure 16
Outlet box
Hanger
bracket
Ceiling canopy
Screws
9. ATTACHING THE FAN
BLADES
Caution: Remove the rubber packing
mounts and discard before installation.
Caution: Motor is shipped with motor
support plate prevent movement during
transportation. Remove the screws from
the motor support plate, discard the motor
support plate and keep the light kit for
future use . (Fig. 17)
Insert the blades through the blade slot in
the decorative housing. Align the holes in
blade and blade bracket, secure with blade
support plate, screws and fiber washers
provided. (Fig. 17)
Screws
Motor support plate
Rubber packing
mounts