Owner`s manual

9
Figure 19
Figure 20
11. INSTALLING THE LIGHT
KIT
NOTE: Before starting installation,
disconnect the power by turning off the
circuit breaker or removing the fuse at fuse
box. Turning power off using the fan switch
is not sufficient to prevent electric shock.
Step 1. Remove the 1 of 3 screws from the
mounting plate and keep it for future use.
Loosen the other 2 screws (Do not remove).
Step 2. Raise and hold the light kit close to
the mounting plate and proceed to do the
wire connections. Connect the white wire
connectors from the light kit and fan, follow
the same procedure with the black wire
connectors. (Fig. 19)
Step 3. Tuck connections neatly into
mounting plate, Place the light plate key
holes over the 2 screws previously loosened
from the mounting ring, turn light kit until it
locks in place at the narrow section of the
key holes. secure by tightening the 2 screws
previously loosened and the one previously
removed. (Fig. 19)
12. INSTALLING THE LIGHT
BULB & GLASS SHADE
1. Install 1 x 100W (MAX.) halogen bulb
(included).
2.Raise glass shade up against the
mounting plate and secure it to fan by
turning glass clockwise until snug. Do not
overtighten. (Fig. 20)
3. Restore power and your light kit is ready
for operation.
13. INSTALLING THE
BATTERY
Install 9 volt battery (included), to prevent
damage to transmitter, remove the battery
if not used for long periods. (Fig. 21)
Figure 21
9 Volt
Battery
Light kit
Screws
Connection
plugs
Bulb
Glass shade