Owner`s manual

5
6. INSTALLATION OF
SAFETY SUPPORT
An additional safety support is provided
to prevent the fan from falling. Secure the
safety cable to the ceiling joist with screw
and washer, as illustrated in Figure 7.
7. MAKE THE ELECTRIC
CONNECTIONS
Remember to disconnect the power.
If you feel you do not have enough
electrical wiring knowledge or experience,
have your fan installed by a licensed
electrician.
This remote control unit is equipped with
16 code combinations to prevent possible
interference from or to other remote units.
The frequency switches on your receiver
and transmitter have been preset at the
factory. Please recheck to make sure the
switches on the transmitter and the
receiver are set to the same position, any
combination of settings will operate the
fan as long as the transmitter and receiver
are set to the same position. (Figure 8)
Step 1 Connect the fan supply (black) wire
to the black household supply wire as
shown in Figure 9.
Step 2. Connect the neutral fan (white)
wire to the white neutral household wire.
Step 3 Connect the fan ground wire
(green) to the household ground wire.
Step 4 After connecting the wires, spread
them apart so that the green and white
wires are on one side of the outlet box and
the black wires are on the other side.
Step 5 Turn the connecting nuts upward
and push the wiring into the outlet box.
Mounting
bracket
Safety cable
Figure 7
Figure 8
Figure 9
Code switch
ON
ON
SUPPLY CIRCUIT
BLACK
WHITE
BLACK
WHITE
GREEN
Outlet Box
Ground
Conductor
Green
Ground
Lead
Ground to
Downrod