Assembly Instructions

SAFETY INFORMATION
3
Please read and understand this entire manual before attempting to assemble, operate or
install the product. If you have any questions regarding the product, please call customer
service at 1-800-963-0211, 8 a.m-6 p.m., EST, Monday-Thursday, 8 a.m.-5 p.m., EST, Friday.
 The installation of this appliance must conform with local codes or , in the absence of local codes,
with the National Fuel Gas Code, ANSI Z 221.3/NFPA 54.
 This grill is intended for use outdoors and should not be used in a building, garage or any other enclosed or
covered area.
 This outdoor grill is not intended for installation in or on recreation vehicles and/or boats.
 A minimum clearance of 36 inches from combustible constructions to the sides of the grill and 36
inches from the back of the grill to combustible constructions must be maintained. This outdoor
cooking gas appliance must not be placed under overhead combustible construction.
 The use of an electrical source requires that when installed, the grill must be electrically
grounded in accordance with local codes or in the absence of local codes, with ANSI/NFPA 70, or the
Canadian Electrical Code, CSA C22.1. Keep electrical supply cords and the fuel supply hose away
from heated surfaces.
 Inspect the hoses before each use for excessive abrasion or wear, or cuts that may affect
safe operation of the grill. If there is evidence of excessive abrasion or wear, or the fact that
the hose is cut, it must be replaced prior to the grill being put into operation. The
replacement hose assembly must be those specified by the manufacturer.
 Keep your grill in an area clear and free from combustible materials, gasoline and other
flammable vapors and liquids.
 DO NOT obstruct the flow of combustion and ventilation air to this appliance.
 Keep the ventilation openings of the tank enclosure free and clear of debris.
 Check all gas connections for leaks with a soapy water solution and brush. Never use an
open flame to check for leaks.
 Never use charcoal in the grill.

Never use the grill in windy areas.
 Only a 20 lb. LP-gas cylinder is allowed. The cylinder must be
constructed and marked in accordance with the Specifications for LP
Gas Cylinders of the U.S.Department of Transportation (D.O.T.) or the
National Standard of Canada, CAN/CSA-B339, Cylinders, Spheres and
Tubes for Transportation of Dangerous Goods; and Commission.
Dimensions for a 20 lb. LP-Gas cylinder are:
 Never use the grill without the drip tray installed and hung under the burner box. Without the
drip tray, hot grease and debris could leak downward and produce a fire hazard.
 Use only the gas pressure regulator supplied with this appliance. This regulator is set for an
outlet pressure of 11.0 wc.
 The cylinder used must include a collar to protect the cylinder valve.
 Do not store a spare LP-gas cylinder under or near this appliance.
 Never fill the cylinder beyond 80 percent full.

The regulator and hose assembly must be routed through the left leg assembly. Regulator
must be locked with regulator hose lock before connect with LP tank. See page 18 for
detailed assembly instructions.