Assembly Instructions

25
Match Lighting Instructions
IMPORTANT: The hood must be open when match lighting any burner.
1. Turn on gas supply
a. If portable, at the LP cylinder valve.
b. If permanent gas supply, at the manual gas shutoff valve.
2. Locate the flame observation holes on each side.
3. Access the match holder stick under right side table.
4. Attach either the match or paper to the clip (Fig.29), light the match
and insert it close to the ports of the burner, and push and turn the
depressed knob to the left to “MAX” position.
Fig. 29 Match/Paper Lighting Illustration
5. The center burner (if needed) can be lit from center grid by inserting the
match clip into the front side of heat tent. Light this burner before igniting
both outside burners.
6. Depress burner valve for that burner and turn to “MAX.”
7. Observe that the burner has ignited. Remove the match and extinguish.
8. Repeat steps 2-6 for the next burner.
Breaking in Your Grill
When firing your grill for the first time, it is advisable to run the main burner(s) on
“MAX” for 20 minutes with the hood down, and then turn the main burners off. This
tempers the grill.