Use And Care Manual

25
OPERATING INSTRUCTIONS
Checking the Flame
Refer to Fig.32 below(side view of grill)for where to check the flame after the
grill is lit.Make sure you have a stable,mostly blue flame.
Fig.32
Flame Observation Hole
Air Shutter Adjustment
The gas burner shutters are adjusted at the factory for your convenience.The
settings are : (a) 1/4 in.open for LP gas.
If you desire to fine tune your shutter adjustment(or if your flame is more
yellow rather than blue),please follow this procedure.
WARNING:Do not touch burner after adjustments.The burner is hot.
a.The shutters are located on the end of the gas burners underneath the
firebox. See Fig.33.
b.Loosen the air shutter screw.
c.Light the burner to be adjusted.
d.With a protected,gloved hand,fine tune the air shutter until a stable,mostly
blue flame is observed through the flame observation hole on each side of
the firebox.Acceptable flames are shown in Fig.34.
e.Tighten the air shutter locking screw enough to hold the shutter in place.
f. Repeat procedure on other burners.
Fig. 34 Acceptable Flame only(a)
Air Shutter
(a)
(b)
(c)
Fig.. 33 Air Shutter
参考下面的图33(格栅的侧面图)，在格栅放好后检查火焰的位置。确保你有一个稳定的，主要是蓝色的火焰。
检测火焰
警告:调整后请勿触摸燃烧器。炉子是热的。
a。百叶窗位于燃烧室下面的燃气燃烧器的末端。看到Fig.26。
b。松开气闸螺丝。
c。点燃需要调整的燃烧器。
d。用一只带着保护手套的手，微调空气挡板，直到通过燃烧室两侧的火焰观察孔观察到稳定的、主要是蓝色的火焰为止。可接受火焰如图27所示。
e。拧紧气闸锁紧螺丝，使其足以固定住快门。
f.对其他燃烧器重复操作。
燃烧器哦风门调节
为了您的方便，工厂调整了煤气燃烧器百叶窗。设置:
1/4。打开LP气体。
如果你想调整你的快门速度(或者你的火焰是黄色而不是蓝色)，请遵循这个步骤。