Use And Care Manual

Assembly Instructions

Side furnace body assembly

1、Install the side furnace valve body into the side furnace assembly's body

mounting hole and tighten it with M4x8 screws.

Hardware Used

M4x8 : x2Screw

Hardware Used

Assembly of side burner

1、 As shown below, install the side burner into the side burner assembly and

tighten it with M4x8 screws.

2、Install the knob on the stem of the side burner valve body.

2、Insert the wire of the ignition needle of the side furnace into the igniter

terminal of the valve body of the side furnace.

Note: When installing side burner, the side burner

body must be inserted correctly into the burner.

Fig.21

Fig.22

M4x8 : x2Screw

注意：安装边炉燃烧器时，必须正确的将边炉阀体插进燃烧器内。

2、将边炉点火针的导线插入边炉阀体的点火器端子上。

1、如下图，将边炉燃烧器安装边炉总成内，并用M4x8螺钉紧固。

17.边炉阀体的装配

2、将旋钮安装在边炉阀体的阀杆上。

18.边炉燃烧器的装配

1、将边炉阀体安装在边炉总成的阀体安装孔内，并用M4x8螺钉紧固。

Ignition wire connection