Service manual

SERVICE TOOLS
SM A-7 G031/G032
APPENDIX
Service Tool Menu
Entering This Menu
1. Turn off the printer.
2. Turn on the printer again while pressing the “On Line” and “Menu” keys
together.
3. The service tool menu will be displayed.
NOTE: An IC card is not required to boot up to the service tool menu.
Menu Contents
Menu Item Contents
Factory Test Pattern This is the same as in the IC card boot service menu.
Downloading This is the same as in the IC card boot service menu.
Clear NVRAM This is the same as in the IC card boot service menu.
Copy to CARD This is the same as in the IC card boot service menu.
DIMM to Memory
Downloads from a DIMM card plugged into the printer into the
flash memory.
1.2.3 STINGER SERVICE UTILITY (SSU)
To download firmware from a PC to the printer, SSU running on a Windows PC can
be used.
NOTE: Use only the “Download” menu and “Byte Swap” buttons. The other
buttons are for designer use only.
a) Download button:
Downloads new controller firmware into the printer.
b) Byte Swap menu:
Makes a byte-swapped file for downloading from PC to printer via a parallel
cable.
SSU will be provided as an SSU.ZIP file. The SSU.ZIP includes seven files, as
follows:
• download.hed
• gzip.exe
• Paiview.exe
• Pindump.exe
• stinger.exe
• stinger.ico
• Xpaipal.smp
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA