Operating instructions

16
Setting a Stack of Originals in the Document Feeder
You can insert a stack of originals into the document feeder. These originals are indi-
vidually fed onto and removed from the exposure glass (platen glass).
Note
❐ Some originals are unsuitable for the document feeder. ☛ See page 14.
❐ Do not press down or hold originals after inserting them.
❐ While originals are fed from the original table to the exposure glass (platen glass),
do not pull them out.
❐ Do not lift the document feeder until the original has been completely fed out.
1
Correct any curl, fold, or crease in the
originals before setting the originals.
2
Make sure the Insert Original indica-
tor is lit and the exposure glass (platen
glass) is clear of originals.
3
Adjust the guide to the original size.
4
Set the originals face up into the docu-
ment feeder until the Insert Original
indicator goes off.
Note
❐ The last page should be on the bot-
tom.
❐ The original guide must touch the front
side of the originals.
❐ Do not stack originals above the limit
mark.
Setting a Stack of Originals in the Document Feeder
TRSR050E
TRSR020E
2
1
1: Limit mark
2: Original guide