Operating instructions

156

Setting Films in the Holder (If Needed)

Check which type of holder you should use. ☛ See page 154.

Slide Holder/Glass Mount Film Holder

Note

❐ The slide holder is covered with glass. Set the mount films in the slide holder.

❐ The glass mount film holder is not covered with the glass. Set the glass mount films

(covered by glass) in the glass mount film holder.

❐ Positive films are usually set in a slide mount or glass mount. If you use positive film

not set in a mount, set it in the film strip holder. ☛ See below.

Open the cover of the slide holder or

glass mount film holder, and set the

slides in the holder one by one.

Note

❐ Set the front side of the film face down

when setting in the slide holder or

glass mount film holder.

❐ When setting in the slide holder, make

sure that all slides are aligned with the

glass of the slide holder cover.

Close the holder and lock it.

Film Strip Holder

Note

❐ Negative film usually come in stripes.

❐ Follow this procedure for positive strip film as well.

Open the film strip holder. Put the

front side of the film face down and

set it in the film strip holder.

Note

❐ When setting film, leave the base film

in the film strip holder. This is conve-

nient when performing shading again.

Preparing the Film

TRSR0L0E

TRSR0K0E

1. Back

2. Front