Operating instructions

Machine Does not Print

Is the

Data In

indicator

blinking or lit after start-

ing the print job?

If not, the data is not being sent to the printer, or the printer

may be resetting the print job because there was a long de-

lay in receiving the data from the computer.

❖

If the printer is using "I/O Timeout"

Increase the value of the "I/O Timeout" setting of the "IP-

DL-C Menu" or "RPS2 Menu". Or set the "I/O Timeout"

value to "0" (this is the off setting).

Set a longer [

Wait timeout

] period accessing the printer

properties when the RICOH-SCRIPT2 printer driver is

selected.

❖

If the printer is connected to the computer using the in-

terface cable

Confirm that the printer port settings are correct. For a

parallel port connection, port LPT1 or LPT2 should be

set.

Reference

For more information on the printer port settings, see

the notes after this table.

❖

Network Connection

Contact your network administrator.

If the

Data In

indicator is blinking or lit.

The printer may be resetting the print job. Take the follow-

ing steps to correct the situation.

• Increase the "Job Timeout" setting of the "IPDL-C Menu"

or "RPS2 Menu".

• Confirm that the printer driver settings are correct.

• Change the "Transfer" setting of the "System Menu".

• Confirm that the "Parallel" of the "System Menu" is cor-

rect.

Possible Cause Solutions