Operating instructions

Error & Status Messages on the Operation Panel
21
3
Note
❒
If you cannot solve the problem by taking above actions, turn the power off
and then on again. If this does not clear the error message, write down the er-
ror number and the message, and contact your sales or service representative.
Getting Printer Information over the Network
Printer current status
You can check the printer's status using the telnet command.
❖
telnet
Use status command. For more information, see “Remote Maintenance by tel-
net (mshell)” in the “Operating Instructions” of Network Interface Board in-
cluded in the CD-ROM.
86:Error You may be trying to print
with the wrong printer driv-
er.
Confirm that you are using
the correct printer driver.
You might not be using the
correct interface cable.
Confirm that you are using
the correct interface cable.
91:Error An error has occurred in the
printer's standard memory.
Turn off and on the power
switch.
94:Error An error has occurred in the
printer's standard memory.
Turn off and on the power
switch. Contact your sales or
service representative.
Message Description Comments
Call Service There is malfunction in the
printer.
Turn the printer off and then
on.
If this does not clear the prob-
lem, contact your sales or ser-
vice representative.
Close Front Cover The front cover is open. Close the front cover.
Close Bank Cover The bank cover is open. Close the bank cover.
Close Sorter Cover The sorter cover is open. Close the sorter cover.
Close Right Cover The right cover is open. Close the right cover.
Close Left Cover The left cover is open. Close the left cover.
Duplex Tray: Not Set
Correctly
The duplex tray is not in-
stalled correctly.
Install the duplex tray cor-
rectly.
Message Description Comments