Operating instructions

Troubleshooting
20
3
Warming Up The printer is preparing for
printing.
Wait until the printer is
warmed up.
Waste Toner is
Full
The waste toner bottle is full. Replace the waste toner bot-
tle. Contact your sales or ser-
vice representative.
A3:Error There is too much data for the
I/O buffer to handle.
Check if the interface cable is
inserted into the printer and
your computer securely.
Check if the interface cable is
not damaged or broken.
Increase the size of I/O buff-
er.
A6:Error There is not enough printer
memory to print one or more
of the pages in the print job.
Change the Color Level using
the printer driver to set the
image resolution to [
Fast
], or
change the Color Level to [
1
bit
]. Turn on “Image Memo-
ry” using the printer's “Sys-
tem Menu” to turn on “Image
Memory”.
AB:Error The printer is unable to pro-
cess the data you are trying to
print.
Reduce the amount of data
being sent to the printer.
B1:Error An error has occurred in the
standard parallel interface.
Contact your sales or service
representative.
B3:Error The printer setting is wrong. Reset the printer using
"Menu Reset" of the "Mainte-
nance" menu.
⇒
P.63
“Reset-
ting Menus”
B4:Error An error has occurred in the
IC card slot.
Contact your sales or service
representative.
B5:Error An error has occurred in the
RICOH-SCRIPT2 module.
Contact your sales or service
representative.
B7:Error An error has occurred in the
network interface board.
Turn the printer's power
switch off and on. Contact
your sales or service repre-
sentative.
85:Error An error has occurred in the
printer's standard memory.
Turn off and on the printer's
power switch. Contact your
sales or service representa-
tive.
Message Description Comments