Operating instructions

Message List
75
5
At the beginning of the message, the IP address of the client is displayed with-
in parentheses.
❖
When using SNMP
print requests full Cannot accept the print request (max. 5 re-
quests). Confirm the status of the printer
with mshell, and print it again after the
number of print requests becomes less
than 5.
printer permission denied Cannot get a permission to use the print-
er. Confirm the access rights with the ac-
cess control address and the access control
mask.
printer refuse Something is wrong with the printer.
Confirm the status of the printer.
Exit snmpd The agent is complete. Reset the printer
or turn the printer off and on.
recvfrom:packet discarded,length(Recep-
tion packet length)> (Packet size),from
addr <Address of partner point>
The received packet was ignored since
the length of the packet exceeds the limit.
Confirm whether the administration sta-
tion sent a packet whose length was long-
er than 1025 bytes.
session <Community name appointed>
not defined
The community name of the received
packet is not defined. Confirm that the
community name of the administration
station is the same as that of the printer.
snmpin:Bad use of session <community
Name> from <Address>
The community name of the received
packet is not the same as that of the ad-
ministration station. Confirm the com-
munity name of the printer.
snmpin:error in snmpdecipher,code (<Er-
ror No.>)
An error occurred on the received packet.
Check if the number of the objects sent
from the administration station is more
than 31 and if there are wrong MIB re-
quests.
snmpin:error in snmpservsend,code (<Er-
ror No.>)
Cannot send a response packet. Normal-
ly, this message is followed by the mes-
sages below *1 *2.
snmpin:pkt too large,code (<Error num-
ber>)
*1
The response packet to the request is too
big to send. Reduce the number of the ob-
jects per request.