Operating instructions

Appendix
74
5
NetBEUI (When the Network Interface Board is started)
TCP/IP
❖
When the address is configured
❖
When using lpr
No local target for “print server name” Cannot get routing information on the file
server. If a different frame type is config-
ured from that used on the network, you
should select "Auto Select" as a frame
type.
Required file server (“file server name”)
not found
Cannot find the required file server.
Required print server (“print server
name”) not found
Cannot find the print server. Confirm the
name of the print server.
Unable to attach to print server (“print
server name”)
Cannot connect to the print server. The
print server refuses a connection for some
reason. Confirm the configuration of the
print server.
Back to default name (<Computer name>) The same Computer name is detected on
the network. As unable to add computer
name to the suffix, the computer name
changed to the default name. Configure a
new computer name that is unique.
Print session full Cannot accept the print session.
Required computer name (<Computer
name>) is duplicated name
The same Computer name is detected on
the network. The start job determines the
computer name by adding the computer
name to the suffix (0,1....). Configure a
new computer name that is unique.
Invalid gateway address The Gateway address is not correct for the
selected IP address.
filter data error Some data cannot be handled by the filter
option. Confirm the file code and the set-
tings of the filter option.
lost connection The connection was cut by a counterpart.
Check the printer to which you requested
to print.