Operating instructions

Remote Maintenance by Telnet (mshell)
65
5
Note
❒
When using the TCP/IP protocol, type ip followed by a space and then the
IP address.
❒
When using the IPX/SPX protocol, type ipx followed by a space, the IPX
address followed by a decimal and then the MAC address of the Network
Interface Board.
The following is an example of how to configure registration number 3 with
the IP address 192.168.15.16.
msh> snmp 3 ip 192.168.15.16
The following is an example of how to configure registration number 3 with
the IPX address 7390A448, and the MAC address 00:00:74:62:5C:65.
msh> snmp 3 ipx 7390A448.000074625C65
Changing the password
Use the passwd command to change the remote maintenance password.
Important
❒
Be sure not to forget or lose the password.
Note
❒
The default factory password is “password”.
A
Type “passwd”.
msh> passwd
B
Type the current password.
Old password:
C
Type the new password.
New password:
Note
❒
The password must consist of 3 to 8 alphanumeric characters and symbols.
Upper and lower case characters are considered unique. For example, R is
different from r.
❒
The password is the same as that used in the configuration of the Network
Interface Board using a Web browser and that used in NIB Setup Tool. If
you change a password on the mshell, the other passwords are also
changed.
D
Type the new password again.
Retype new password: