Operating instructions

Configuring the Printer for the Network with the Operation Panel
16
2
A Press
{U}
or
{T}
to display
“37.Net Boot”.
<System Menu> j
37.Net Boot l
B Press
{
# Enter
}
.
The current setting appears on
the panel display.
<Net Boot> j
*None l
C Press
{U}
or
{T}
to display the
method you want to use.
D Press
{
# Enter
}
.
I If you use NetWare, select the
frame type for NetWare.
Select one of items below if neces-
sary.
• Auto Select (Default)
• Ethernet 802.3
• Ethernet 802.2
• Ethernet 2
• EthernetSNAP
Note
❒
Usually, use the default setting
(“Auto Select”). However, if
you select “Auto Select”, the
frame type detected by the
printer first is adopted. If your
network can use more than two
frame types, the printer may fail
to select the correct frame type,
if “Auto Select” is selected. In
this case, select the appropriate
frame type.
A Press
{U}
or
{T}
to display
“38.Frame NW”.
<System Menu> j
38.Frame NW l
B Press
{
# Enter
}
.
The current setting appears on
the panel display.
<Frame NW> j
*Auto Select l
C Press
{U}
or
{T}
to display the
frame type you want to use.
D Press
{
# Enter
}
.
J Reset the printer to apply the set-
tings.
A Press
{
On Line
}
to enter the of-
fline condition.
The On Line indicator turns off.
B Press
{
Reset
}
.
K Print the configuration page to
check settings you have made.
A Press
{
Menu
}
.
B Press
{U}
or
{T}
to display
”List Print”.
C After confirming that “Con-
fig.Page” is on the display,
press
{
# Enter
}
D Press
{
# Enter
}
.
The configuration page is now
printed. Check the contents of
the configuration page.
E Press
{
On Line
}
.
The “Ready” message appears
on the panel display.