Operating instructions

Configuring the Printer for the Network with the Operation Panel
15
2
C Press
{U}
or
{T}
to set the left-
most digit of the IP address.
111.022.033.044
j jl/#
D Press
{
# Enter
}
.
The pointer (
U
) moves to the
next digit as shown.
111.022.033.044
j jl/#
Note
❒
You can return the pointer
(
U
) to the previous (left) digit
by pressing
{
Escape
}
.
❒
If you press
{
Escape
}
when
the pointer (
U
) is on the left-
most position, the selected IP
address is reset.
E Press
{U}
or
{T}
to set the sec-
ond digit of the IP address.
191.022.033.044
j jl/#
F Press
{
# Enter
}
.
G Repeat steps E and F to set
the rest digit of the IP address.
191.168.015.016
j
Check if the pointer (
U
) is at the
rightmost digit, and press
{
# En-
ter
}
to register the IP address
you selected.
<System Menu> j
32.IP Address l
F If you use TCP/IP, you should as-
sign “33.Subnet Mask” and
“34.Gateway Add” following the
same procedure for setting the IP
address.
G If you use TCP/IP, set the “35.Ac-
cess CTL.” and “36.Access Mask”
following the same procedure for
setting the IP address, if neces-
sary.
H If you use TCP/IP, you should
make settings for “37.Net Boot”.
You can select how to assign the
printer's address using the com-
puter. Select one of the items on
the table below.
*1
ARP+PING
*2
RARP+TFTP
*3
BOOTP
*4
DHCP
Note
❒
You must configure your server
to use “RARP+TFTP”, “BOOTP”
or “DHCP”.
Menu item on
the panel
display
Available method
AR
*1
RA
*2
BO
*3
DH
*4
None
(Default Setting)
RARP+TFTP
'
BOOTP
'
RARP & BOOTP
''
DHCP
'
ARP+PING
'
ARP & RARP
''
ARP & BOOTP
''
ARP & RARP &
BOOTP
'''