Operating instructions

Connecting the Machine

Connecting the Machine Using the Network Interface Board

Connect the machine to the network using the Network Interface Board.

Follow these steps to connect the machine.

A Confirm that you have the correct cable.

Note

❒

In a 100BASE-TX environment, be sure to use a properly shielded and

grounded cable (STP) for the connection to your host computer (and/or

HUB) in order to meet FCC and EMC Directive 89/336/EEC emission

guidelines.

B Confirm that the machine is turned off.

C Loop the network interface cable. The loop should be about 15 cm (6”) from

the end of the cable on the end closest to the printer.

D Attach the ferrite core to the loop.

E Attach the network interface cable to the 10BASE-T/100BASE-TX port on

the printer.

Reference

See P.1 “Connecting the Machine” to be sure of the position of the 10BASE-

T/100BASE-TX port.