Service manual

1st 2nd 3rd Display Function
Default,
( ): For Europe
Settings/Range Comments Report
5 810 1 Fusing SC Reset
Resets a type 1 service call
condition that was caused by the
fusing unit. After doing
SP5-810-1, turn the copier main
switch off and on.
- 1: Reset
See section 6,
"Troubleshooting" for details.
5 810 2 SC Reset
Resets a type 1 service call
condition that was caused by an
error other than a fusing unit error.
After doing SP5-810-2, turn the
copier main switch off and on.
- 1: Reset
See section 6,
"Troubleshooting" for details.
5 812 Service Tel.No.
Use this to input the telephone
number of the service
representative (this is displayed
when a service call condition
occurs.) Maximum 15 digits.
Press the . key to input a pause
(-). Press the Clear Modes key to
delete the input telephone number.
- 15 digits
5 816 RDS On/Off
For use in Japan only.
0 0: OFF, 1: ON
Do not change the factory
settings.
5 817 Repair Time Tx - ON: Start, OFF: C/S
5 818 6 IPU Diagnostic Tx - 1: Start
5 818 7 Ext-IPU Diagnostic Tx - 1: Start
5 818 8 IDU Diagnostic Tx - 1: Start
5 818 9 Printer Diagnostic Tx - 1: Start
5 901 Touch Panel Calibration
Selects the touch panel calibration
conditions.
0 0: OFF, 1: ON
For details, see the
Replacements and
Adjustments section.
5 955 Select Printer Test Ptrn Selects the printer test pattern. 0 0 to 32
For details, see the Service
Tables section. <Section 4
(1.3.8)>
OPERATION AND SYSTEM
Rev. 11/96
SM APPENDIX 11-54 A166/A187/A189
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA