Service manual

1st 2nd 3rd Display Function
Default,
( ): For Europe
Settings/Range Comments Report
2 310 4 Forced Blt Cleaning Time
Sets the duration for the forced
belt cleaning (2-311).
80 0 to 999 (s)
Do not change the factory
setting.
2 311 Forced Belt Cleaning Cleans the belt. - 1: Start
Do this after replacing the
transfer belt.
2 503 Blt Cleaning Timing Shft
If the belt cleaning blade releases
the blade earlier (40mm), this
prevents the toner scattering from
the blade onto the belt at the
leading edge.
1 (0)
0: OFF (Normal)
1: ON (40mm)
This timing shift has a side
effect: Bk images might be
shifted.
2 602 PTL ON/OFF
Selects whether PTL works or not
for the printer model.
0 0: No, 1:Yes
Used only for the printer
version.
2 912 1 Temp. Display
Displays the current temperature
sensor output.
-
0 to 6553.5 (
°
C)
This shows the output from
the thermosensor on I/O
control board 1 at the rear of
the machine.
2 912 2 Humidity Display
Displays the current humidity
sensor output (relative humidity).
- 0 to 6553.5 (%)
This shows the output from
the humidity sensor on I/O
control board 1 at the rear of
the machine.
2 913 Toner Overflow Sn
Selects whether the used toner
sensor is used or not.
1 0: ON, 1: Yes
Do not change the factory
setting.
2 914 1 Revolution Interval:K
Sets the revolution interval
(number of copies) of the
development unit during single
color copying for Bk.
50 0 to 99 (copies)
Do not change the factory
setting.
2 914 2 Revolution Interval:CMY
Sets the revolution interval
(number of copies) of the
development unit during single
color copying for C, M, Y
50 0 to 99 (copies)
2 915 1 Belt Trans Crnt Ratio Changes the belt transfer current. 100 0 to 200 (%)
Do not change the factory
setting.
2 915 2 Paper Trans Crnt Ratio
Changes the paper transfer
current.
100 0 to 200 (%)
Do not change the factory
setting.
AROUND THE DRUM/BELT UNITS
SM APPENDIX 11-29 A166/A187/A189
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA