Service manual

6. SERVICE TABLES
6.1 DIP SWITCHES
DPS 101
Function
1234
0 0 0 0 Normal setting
1 0 0 0 One-sided thin original mode free run with paper (35 cpm)
0100
One-sided thick original mode (normal mode) free run with
paper (35 cpm)
1100
One-sided thick original mode (normal mode) free run
without paper (35 cpm)
0 0 1 0 Two-sided mode free run with paper (35 cpm)
1 0 1 0 Two-sided mode free run without paper (35 cpm)
1 0 0 1 One-sided thin original mode free run with paper (25 cpm)
0101
One-sided thick original mode (normal mode) free run with
paper (25 cpm)
0 0 1 1 Two-sided mode free run with paper (25 cpm)
1 0 1 1 Not used
1 1 0 1 Solenoid test
0 1 1 0 Motor test
1 1 1 0 Combine two originals mode free run with paper
0 0 0 1 Not used
0 1 1 1 Not used
1 1 1 1 Indicators On
NOTE: a) Paper will automatically feed after 3 seconds when the "with
paper" free run modes are selected.
b) To prevent the friction belt from wearing, open the feed-in cover
when performing the "without paper" free run modes.
To make a free run
1. Set up dip switches 1 to 4 for the required free run mode the test begins
automatically.
2. To stop the free run, put the dip switches back to 0.
Rev. 11/96
SERVICE TABLES
A166/A187/A189 7-16 SM
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA