Service manual

19. Open the paper it door [A].

20. Remove the fusing entrance guide plate [B] (2 screws).

NOTE: Be sure to use the upper screw holes when reinstalling the fusing

entrance guide plate. The lower screw holes are used to adjust the

paper feed path (see procedure 9.12).

21. Replace the pressure roller [C] and the pressure roller shaft bearings [D].

1) Remove the pressure roller lamp [E] by pulling it forward and

disconnecting the connector from the rear lamp holder.

2) Remove the pressure roller.

[C]

[E]

[D]

[A]

[B]

Replacement

and

Adjustment

PAPER TRANSPORT AND FUSING

SM 5-79 A166/A187/A189

CÓPIA NÃO CONTROLADA