Service manual

8.5 BY-PASS FEED PAPER SIZE SENSOR REPLACEMENT

1. Remove the by-pass feed table (see procedure 8.1).

2. Remove the by-pass feed table base [A] (2 screws).

3. Move the by-pass feed table cover [B] to the right (this releases the latch)

Remove it from the by-pass feed table base.

4. Replace the by-pass paper width detection board [C] (1 screw).

NOTE: 1) When installing the by-pass paper width detection board,

take care not to bend the terminal plate.

2) When routing the sensor harness, ensure that it is not caught

between the screw and the by-pass feed table cover. Run the

harness through the notch [D] in the by-pass feed table base.

Latch

[C]

[B]

[D]

[A]

PAPER FEED AND REGISTRATION

A166/A187/A189 5-64 SM

CÓPIA NÃO CONTROLADA