Service manual

7.3 BELT TRANSFER CORONA WIRE
1. Remove the corona unit from the transfer belt unit (see section 3.
COPIER INSTALLATION PROCEDURE).
2. Remove the front and rear end block caps [A].
3. Remove the corona wire [B] (1 spring).
NOTE: 1. When cleaning or replacing the corona wire, take care not to
deform the mylar on the corona unit.
2. Make sure the corona wire is properly set in the V-gutter of
both blocks.
[A]
[A]
[B]
TRANSFER BELT UNIT
A166/A187/A189 5-56 SM
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA