Service manual

11. Remove the developer cover [A].

12. Attach the developer collection bottle/supply funnel ass’y [B] to the

development unit using the screw [C] (M4 x 6).

NOTE: 1. Before tightening the screw [C], ensure the two tabs [D] are

completely inserted into the slots and the screw holes are

aligned correctly.

2. Be sure to use the correct screw [C] (M4 x 6) to attach the

developer supply funnel. If a screw longer than screw [C] is

used, the development paddle will be damaged by the longer

screw.

3. When installing the developer supply funnel, take care not to

misalign the sponge [E] or developer may spill out.

4. Hold the developer supply funnel in position when tightening

the screw. This is to prevent the screw holes from misaligning.

5. Never overtighten the screw [C]. If the screw is overtightened,

the development unit’s screw hole (made of aluminum) may

be damaged and the entire development unit may need to

be replaced.

[A]

[B]

[C]

[D]

[E]

DEVELOPMENT UNIT

A166/A187/A189 5-40 SM

CÓPIA NÃO CONTROLADA