Service manual

11. In the 1st scanner, loosen the screw [A] of both wire clamps. (Only the
front scanner wire is shown above.)
12. Route the new scanner wire:
The scanner wire has a ball attached to one end and a ring attached to
the other. These ends are used to route the wire properly. The wire also
has a ball attached to its middle.
1) Put the middle ball in the groove on the pulley [B] and wind the wire
eight times, as shown. Make sure that the red reference mark [C] on
the wire is positioned as shown.
2) Route the ball end of the wire along the pulley, as shown. Place the
ball into the hole in the frame [D].
3) Route the ring end of the wire along the pulley, as shown. Hook the
ring onto the wire tension bracket [E].
[C]
1st turn
7th turn
Inside
Outside
[A]
[B]
[D]
[E]
Replacement
and
Adjustment
SCANNER UNIT
SM 5-21 A166/A187/A189
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA