Service manual

No.:
Function
name
Description
Choices (range) and
specification method
6: Auto Color
Select
Sensitivity
(Auto color
selection)
When in Auto Color Select mode, you can specify
the level at which the copier identifies whether an
original is “Color” or “Black.”
The copier easily identifies black originals when
you specify a level close to “Black”, and color
originals when you specify a level close to
“Color.”
7: Auto Color
Select
Mode
Priority
(Auto color
selection)
When in Auto Color Select mode, you can set the
copier to use either the “Black” or “Color” mode
preferentially to make copies.
Select the mode (Black or Color) used
frequently to make copies in the Auto Color
Select mode.
8: Color
Sensitivity
(Color
conversion)
You can adjust the width of colors before
conversion within 5 levels.
For example, when you specify yellow with the
color width set to “Wide,” other colors close to
yellow, such as orange and yellowish green,
are also specified. When you set the color
width to “Narrow,” only yellow is specified.
UP-2 Default Margin Settings
No.:
Function
name
Description
Choices (range) and
specification method
1: Default
Margin:
Width
Changes the default margin direction and width. Specify in the range of
1~20 mm,
0.1~0.8 inches
(in 1 mm, 0.1 steps)
2: Side 2
Default
Margin
Width:
Changes the default side-2 margin direction and
width.
Specify in the range of
1~20 mm,
0.1~0.8 inches
(in 1 mm, 0.1 steps)
3: Auto Side
2 Margin
Adjustment
When you make two-sided copies from one-sided
originals, a right margin is put on the back side
automatically if this is set to "ON".
This function can be used only if your copier
has a duplex tray.
1On
2Off
0mm
0mm
1B/W
2
3
4
5 Color
1 Narror
2
3
4
5 Wide
1B/W
2 Full Color
Service
Tables
USER PROGRAM MODES
SM 4-19 A166/A187/A189
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA