Service manual

8-2) When the trailing part of the image is dark (as shown in [A]).

a) Move the front and rear arm guides [B] to the right so that the

mirror angle is reduced (2 screws each).

NOTE: Position the arm guides in the same location at the

front and rear, using the ruled marks. (refer to the

illustration above). This prevents the

mirror from being twisted.

b) Make a copy of the orange film.

c) Repeat steps a) and b) until the orange image is even.

18. Check copy images from positive or negative films.

[B]

[A]

FILM PROJECTOR UNIT (A718) INSTALLATION

A166/A187/A189 3-60 SM

CÓPIA NÃO CONTROLADA