Service manual

10. Insert the film strip holder [A] into the film projector unit at the base film

setting position.

NOTE: Push the film strip holder gently to confirm that the film strip

holder has been completely inserted.

11. Turn on the test switch [B] on the projector control board and turn on the

projection unit main switch [C].

CAUTION

The lamp housing and reflector [D] will become very hot. The lamp

cooling fan [E] will start turning suddenly when the lamp housing

temperature becomes high. Keep hands away from these components

to avoid any injury.

12. Loosen the wing nut [F].

13. Adjust the position of the projected light by turning the dial [G] with a

hexagon wrench [H] until it is at the center of the 4" x 5" frame [I] reflected

in the mirror unit.

14. Tighten the wing nut [F].

15. Turn off the projector main switch and the test switch.

16. Reinstall the lamp cover and other covers.

[C]

[I]

[B]

[D]

[F]

[H]

[G]

[A]

[E]

FILM PROJECTOR UNIT (A718) INSTALLATION

A166/A187/A189 3-58 SM

CÓPIA NÃO CONTROLADA