Service manual

5. Remove the lamp cover [A] (1 screw) and open the reflector cover [B]. Then,
plug the projection lamp [C] into the socket. Close the reflector cover.
NOTE: The projection lamp should be fully inserted.
6. Run the optical fiber cable [D] between the projector control board (CN6)
and the copier through the rubber bushing [E], as shown.
7. Connect the power cord [F] to the power inlet and plug it into the wall
outlet.
CAUTION
After plugging the power cord into the wall outlet, do not touch the
electrical components inside the projector unit (other than the test
switch used in steps 11 and 15). Otherwise, you might receive an
electrical shock.
[D]
[E]
[A]
[C]
[B]
[F]

FILM PROJECTOR UNIT (A718) INSTALLATION
A166/A187/A189 3-56 SM
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA