Service manual

3. Set the copier [B] on the paper tray unit [C]. Align the 2 pins [D] on the
paper tray unit with the holes in the base plate of the copier.
4. Open the lower door [E]. Also, open either the LCT [F] or the upper right
door [F], (depending on the type of copier).
5. Secure the copier to the paper tray unit with the joint bracket [G].
6. Connect the cable [H] and optic fiber [I].
7. Attach the support brackets [J] to the bottom of the paper tray unit as
shown (4 screws).
CAUTION
If you do not properly attach the support bracket, the machine may
fall forwards when the paper trays are pulled open.
8. Pull out the paper tray and load paper into it. (The paper size and
direction for each tray should be designated by a customer.)
Position the side and rear fences properly.
9. If necessary proceed to the copier installation procedure. After performing
the copier install return to this section and complete steps 10 through12.
If the copier was installed prior to the installation of the paper tray, turn on
the main switch and complete the following:
10. Enter the proper paper size for each paper tray by following the
procedure in the copier’s manual.
11. Attach the appropriate tray decals [K] which are included in the accessory
box with the main copier.
12. Check the machine’s operation and copy quality.
[B]
[D]
[F]
[I]
[H]
[D]
[G]
[E]
[C]
For Copiers with an LCT:
Do not lift the
copier by holding the LCT unit.
[J]
[K]
PAPER TRAY UNIT (A549/A550) INSTALLATION
A166/A187/A189 3-42 SM
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA